2010-2013 STIP Draft - Laserfiche WebLink

New Search

DRAFT 2010-2013 STATEWIDE TRANSPORTATION IMPROVEMENT PROGRAM KEY TO PROJECT LISTING Shows the name and location of each project Shows estimated amount of funds, the federal share (as applicable), the year the funds are committed, and the type of funds committed to the project i+Ta~++` '~~~:'T'::.,L~~~~ R to=EG+ ~E~ -E~r. j ~a E .tI~: :~iti~~~:n~: r~,niai~a: 3.75' gy v ;a ~~i~: ;~CS~SLC~L: ?>iPt~~ t7~z~: "~:n-4L ~! ~ ~i~1~5;iJ~ ]i:an ;,S~uT 5t~tas: C:~nstsc:~ec~iw3t,.e,-ias'~G~lrf a~~tu~ie~: TS~7~. F ~E%_~ ~,t _G.T.~'~, rye-..~ ="E i : uII;Te ~r~ ~ tl~~: ~'~= Describes the work being done on the project Identifies who is Shows the sponsoring the Shows the project or who primary type year project Identifies which MPO boundary the project falls requested the pro- of work is set to go within (or Non-MPO for those outside). ject to contract There are six primary sections in the ST1P, one for each of the five ODOT regions and one for Statewide programs. The five regional sections are further sorted by County. Projects are then sorted by Route and again by Work Type. The following information appears for each project in this document: • The first element listed is the Project Name with the Key number, a unique numeric identifier that stays with the project for its entire life after the project name. • The Highway Name is directly below the project name. • Under the Highway name is the Route, a more common name for a specific section of roadway. • Below the route are the beginning and ending Milepoints. These identify where the project starts and ends. • Below the milepoints is the ACT (Area Commission on Transportation). • Below the ACT is the MPO. This indicates, when applicable, which Metropolitan Planning Organization boundary the project falls within. If the project is outside an MPO boundary, "Non-MPO" is listed. • Below the MPO is a Description of the main project work taking place. • Up and to the right is the Funding Information Section. First is Planning activities relating to studies, refinement plans, location EIS, MPO planning, State Planning & Research projects. The next four lines are Design, Land Purchase, Utility Relocation and Construction. These are the phases of a construction project. Other is for activities such as Transit (planning, operations, and purchase), other non-construction projects and certain activities unique to a specific project. The Total Cost and Year columns identify how much total funding is programmed for each phase and the year it was started (if prior to the 2010-2013 STIP period) or the year it is planned to begin. Each column to the right of these phases identifies the type of funding programmed and the amount of that fund. Required matching funds are not included in the columns located to the right of the Total Cost column. • Directly below the funding information is the Applicant. This identifies who the project owner is. • To the right of the applicant field is the Status of the project. This indicates what is happening with the project and in what year. • Below the status line is the Work Type. This identifies the primary type of work associated with each project. The STIP work type order is Modernization first, then Safety, Pavement Preservation, Bridge, and Operations, followed by all other work types. T~tai~c_t_ afar. 1_tFumd: Identifies funds committed from the previous STIP ~e}': j=r'~~, ?apt x`and: ~F~ 3ed Prand_ Sb E: Petar~r_ ~har~. '' _ ~ `.:) Unique .~ identifier for each project ~~ tL~ $~;~ ~~ ~!7 Page 4