New Search
Contractors ROE (Generic) - Ex0 <br /> Form Approved - AVP Law 07-09-07 t3Uit.DIN6 AMEt2iC' <br /> i ~ <br /> ;property. in addition, Contractor must ensure that the operators of all equipment are properly trained and competent in <br /> operation of the equipment. In addition, operators must be: <br /> ¦ Familiar and comply with Railroad's rules on IockoutJtagout of equipment. ``mss <br /> ¦ Trained in and comply with the applicable operating rules if operating any by-rail equipment on-track. <br /> <br /> 4 Trained in and comply with the applicable air brake rul®s if operating any equipment that moves rail cars or any other <br /> railbound equipment. <br /> B. All self-propelled equipment must be equipped with afirst-aid kit, fire extinguisher, and audible back up warning device. <br /> C. Unless otherwise authorized by the Railroad Representative, all equipment must be parked aminimum oftwenty-five (25) feet <br /> from any track. Before leaving any equipment unattended, the operator must stop the engine and property secure the equipment <br /> against movement. <br /> D. Cranes must be equipped with three orange cones that wiH be used to mark the working area of the crane and the minimum <br /> clearances to ovefiead poweriines. <br /> V. General Safety Reaureements <br /> A. Contractor shall ensure that all waste is properly disposed of in accordance with applicable federal and state regulations. <br /> B. Contractor shall ensure that all employees partidpate in and comply with a job briefing conducted by the Railroad <br /> Representative, if applicable. During this briefing, the Railroad Representative will specify safe work procedures, (including On- <br /> Track Safety) and the potential hazards of the job. tf any employee has any questions or concerns about the work, the employee <br /> must voice them during the job briefing. Additional job briefings will be conducted during the work as conditions, worK <br /> procedures, or personnel change. <br /> C. All track work pertormed by Contractor meets the minimum safety requirements established by the Federal Railroad <br /> Administration's Track Safety Standards 49CFR213. <br /> D. All employees comply with the following safety procedures when working around any railroad track: <br /> (i) Always be on the alert for moving equipment. Employees must always expect movement on any track, at any time, in either <br /> direction. <br /> (ii) Do not step or walk on the top of the rail, frog, switches, guard rails, or other trade components. <br /> (iii) In passing around the ends of standing cars, engines, roadway machines or work equipment, leave at least 20 feet between <br /> yourself and the end of the equipment. Do not go between pieces of equipment of the opening is less than one car length <br /> (50 feet). <br /> (iv) Avoid walking or standing on a track unless so authorized by the employee in charge. <br /> (v) Before stepping over or crossing tracks, look in both directions first. <br /> (vi) Do not sit on, lie under, or cross between cars except as required in the performance of your duties and only when track and <br /> equipment have been protected against movement. <br /> E. All employees must comply with all federal and state regulations concerning workplace safety. <br /> Contractor's ROE (Generic) - ExD Page 2 Of 2 Exhibit D <br /> Form Approved - AVP Law 07-09-07 Minimum Requirements\ <br /> To Contractor's Right of Entry Agreement <br /> <br />