New Search
Measurement <br /> Logs, chips, poles, and piling must be reported in <br /> thousands of board feet (MBF). Products not measured in <br /> board feet must be converted to MBF. <br /> Per Oregon Administrative Rule [OAR 150-321.005(12)] use <br /> the following criteria for determining which conversion factors <br /> to use. <br /> • When less than 10 percent of the load's log count comes <br /> from logs that have an 8° or larger scaling diameter, use <br /> the Chip logs conversion factor. <br /> • When 10 percent or more of the load's log count comes <br /> from logs that have an 8° or larger scaling diameter, use <br /> the Saw logs conversion factor. <br /> If the logs are to Number of Divide Volume <br /> be used for: units by = (MBF) <br /> q-tj.0-5 11" <br /> Chip logs Tons 11 = l 'I LP "1— <br /> Saw logs Tons 7.5 = 1-2- <br /> Green tons Divide Volume <br /> If the product Is: of chips by = (MBF) <br /> Chips produced in <br /> the woods from: <br /> Dead conifer logs Tons 5 = <br /> Green conifers or <br /> hardwoods Tons 11 <br /> Number Divide Volume <br /> If the product is: of units by = (MBF) <br /> Poles and piling <br /> and they are: <br /> Up to 80'length Poles 8 = <br /> Over 60'length Poles 3 <br /> Comments: <br /> 160-602-201 (Rev.07-16) <br />